There are four separate units;
Research and Technology Development Unit
Product Development and Prototype Production Unit
In these units,
Kaizen Studies
Customer Complaint Solution Studies
Cost Reduction and Standardization Studies
Process Decrease and Acceleration Studies
Process Commonization and Automating Studies
Strength and Capacity Increasing Studies
Thickness, Force, Stress Mass and Topology Optimization Studies
Throw-out Analysis Studies
all kinds of research and development activities are carried out
The company, which is aware of the development of personnel training, gives full support to the training organizations that the staff wishes to participate in with its proposal and the training organized by the R&D and / or human resources. Support for staff participation in graduate and doctoral courses, as well as thesis, project and patent issues are encouraged with prizes.
In the R&D department, the scientific publication archives of various organizations are examined in order to investigate and develop the scientific basis of the product as a requirement of pre and post design. In the R&D studies, academic support has been received from leading universities such as Dokuz Eylül University, Katip Çelebi University, İzmir Institute of Technology, Ege University and Celal Bayar University.
In addition to the support of universities at the project stage, R&D cooperation agreements were signed with Dokuz Eylül University Industrial Application and Research Center (DESUM) and Ege University Science Technology Application and Research Center (EBILTEM).
TUBITAK and TTGV supported projects have been successfully executed and finalized.
Distortion-free cementation of parts made of low carbon lamina.
First time in Turkey, design and production of self adjusting clutch and sensor bearing
Clutch disc design and production for Euro-6 Engine Vehicles
In R&D center, following licenced softwares are used:
AutoCAD
Siemens NX
ANSYS
Workbench
Mechanical
Structural
The products made of geometric designs are pre-validated by the R&D analysis unit in the ANSYS software.
The molds of the products that are designed and validated with computer aided engineering are manufactured in the R & D workshop with 472 m2 area and the first prototypes are produced in the production area. By R&D testing unit; fatigue tests of products, performance tests are completed in test laboratory After the design, prototype and tests are completed within the company, the product is finally tested on the vehicle under real road conditions and the validation is completed before the mass production.
In R&D Test Room we have several test machines as: Clutch cover assembly durability test machine, Release bearing durability test machine, Disc torque-hysteresis test machine, Dual mass flywheel torque-hysteresis test machine, hydraulic-pneumatic bearing durability test machine, Burst test machine. Test facilities will be continuously improved by researching and developing new test devices that will contribute to R&D activities.